What name or part no of this plate 2x2 is?

[Zhengrong Zang]

I am using MLCad to design my train, and I want to use part in attachment, but I can't find it in parts list, does anyone tell me what is this part name of number?

[Philippe Hurbain]

This is a well known Megablock part!!!
Not in LDraw library...

[Zhengrong Zang]

This is a well known Megablock part!!!
Not in LDraw library...

If I want to use it in my MOC, how can I create a dat file easily and simple?

[Max Martin Richter]

As Philo mentioned, this isn't a LEGO piece.
But it was quite simple to create it.
I attached this part.

/Max

PS.: I never thought, that I would do a non LEGO Part here ;-)

[Philippe Hurbain]

Isn't it supposed to have a thickness higher than regular plate? See http://www.eurobricks.com/forum/index.ph...ntry941542

[Zhengrong Zang]

As Philo mentioned, this isn't a LEGO piece.
But it was quite simple to create it.
I attached this part.

/Max

PS.: I never thought, that I would do a non LEGO Part here ;-)

Thank tou very much! Someday Lego might build this parts for SNOT

By the way, can you tell me the simple way to combine exist data to a new part dat file?

[Max Martin Richter]

I used the 'simple' LDDP text editor.
Wrote:

Code:

1 16 0 0 0 1 0 0 0 1 0 0 0 1 3022.dat

for getting the regular 2x2 plate. Then I used the inline function and removed the stud4.dat. Afterwards I added a stud2 group 2x2. And scaled this group at the right position.

/Max

[Santeri Piippo]

Make your train an MPD model and use the part file as one of the sub-models.

[Zhengrong Zang]

I used the 'simple' LDDP text editor.
Wrote:

Code:

1 16 0 0 0 1 0 0 0 1 0 0 0 1 3022.dat

for getting the regular 2x2 plate. Then I used the inline function and removed the stud4.dat. Afterwards I added a stud2 group 2x2. And scaled this group at the right position.

/Max

Thanks a lot, I will try to make my own parts.

[Zhengrong Zang]

Make your train an MPD model and use the part file as one of the sub-models.

I just use it in MLCad without problems, but when I use LPub to create instructions, there is no this parts both in PLI and assembler parts, what do I have to config in LPub?

[Zhengrong Zang]

Make your train an MPD model and use the part file as one of the sub-models.

Well, I got it in LPub! Thanks a lot.