Help with parts creation


Re: Help with parts creation
#15
It can be done Wink
[Image: gunganspliteye.png]
This is just the 1st try, result is not good (split is too sloping).
How it was done:
- Export as .stl
- Open .stl using MeshMixer (free 3D sculpting program)
- Sculpt the eye, restricting action of tools to front eye area using facegroup feature introduced in MM8. Adjust number of triangles using MM reduce tools.
- export back to LDraw with stl2dat.
- Reinsert edge lines from original files
- Despite restricted action of tools in MM, the area around eye moved a bit, so the edge line around pupil dind't fit perfectly anymore. Fixed that by making a subpart from original edge lines, and used unificator+snap on subfiles.
- Created middle edge line with Edger2 + manual edition.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Help with parts creation - by Stan Isachenko - 2012-09-19, 19:10
Re: Need help with 93552 - by Stan Isachenko - 2012-09-20, 10:26
Re: Help with parts creation - by Philippe Hurbain - 2012-11-06, 10:53

Forum Jump:


Users browsing this thread: 1 Guest(s)