[LPub] Change the view of a Callout

[Johann Eisner]

Hello,

I have another problem. I would like to insert a part into another part upside down. In this section I want to use a callout. In the following picture you can see the first part.



In the second picture you see the first and the scond part, but the second part with the wrong direction.



The line which call the subpart: 1 1 0 -40 0 1 0 0 0 1 0 0 0 1 1.ldr

I hace changed the second "1" (red coloured) in the matrix to "-1". In the next picture you can see the result.



Both parts, the part in the callout and the part in the page was rotated. But I want only rotate the part in the page.
I have attached the code.

My qustions now are:
How looks the matrix that the result is as I wish?
How is the impact of the matrix at the callout?

Regards

Manfred

Hi Manfred
The attached code works for me without any problems.
I suspect you rotated the model with a ROTSTEP command before adding the callout.
As a result, the callout also adopts this "relative" rotation.
You can remedy this, as briefly written above, by inserting the line “0 ROTSTEP 0 0 0 REL” in the sub-model of the callout after the header before the first part.

New partfile is attached.