Part 4210 (hose reel)


RE: Part 4210 (hose reel)
#11
(2020-07-31, 16:48)Magnus Forsberg Wrote: I'm thinking the teeth are part of the sloping cone, so the bigger cone has to also be adapted to the 44 teeth. And the edge line.
If you allow the bigger cone to switch from 16 to 48 is wouldn't fit the 44 teeth.

I think I get it. So the larger cone, instead of a primitive, should be directly modeled, along with the 44 teeth, to match a 48-sided inside edge and ring…and the transition between those and the smaller 16-sided cone and rings in the main part gets hidden behind them?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Part 4210 (hose reel) - by N. W. Perry - 2020-07-29, 16:31
RE: Part 4210 (hose reel) - by Alex Taylor - 2020-07-30, 6:56
RE: Part 4210 (hose reel) - by Alex Taylor - 2020-07-30, 6:57
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-30, 14:39
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-30, 17:35
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-31, 16:12
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-31, 19:06
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-01, 0:41
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-01, 7:08
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-02, 3:29
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-03, 23:16
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-10-21, 15:03

Forum Jump:


Users browsing this thread: 1 Guest(s)