Part 4210 (hose reel)


RE: Part 4210 (hose reel)
#7
(2020-07-30, 15:27)Magnus Forsberg Wrote: I think I would make a 1/4 subfile with 11 teeth, or maybe better, a 1/8 with 5,5 teeth.

I'll do the 1/8th then, since it solves both problems (accurate number of teeth, and greater use of subfiles).

Quote:Attach the inner side to a 4-4ndis around the shaft, and hide the outside under the smaller cone.

So the ndis on the inside replaces the disc that's there now? And the cone just the way I have it now, hiding the outside of the subpart?

(By the way, my current version is based on 2585.dat as far as how the prims overlap the teeth subfile. But I can see how the ndisc is an improvement.)

Quote:btw.
dont use the stud3 primitive like that. I know it was used like that in the old file, but must be corrected now.

OK, I'll replace it. What should it be, a cylc?

And for the pinhole, I'm thinking a cyl, a cone and a cylj (subfiled of course)?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Part 4210 (hose reel) - by N. W. Perry - 2020-07-29, 16:31
RE: Part 4210 (hose reel) - by Alex Taylor - 2020-07-30, 6:56
RE: Part 4210 (hose reel) - by Alex Taylor - 2020-07-30, 6:57
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-30, 14:39
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-30, 17:35
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-31, 16:12
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-31, 19:06
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-01, 0:41
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-01, 7:08
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-02, 3:29
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-03, 23:16
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-10-21, 15:03

Forum Jump:


Users browsing this thread: 1 Guest(s)