Part 4210 (hose reel)


RE: Part 4210 (hose reel)
#5
(2020-07-30, 7:12)Magnus Forsberg Wrote: Seems to be accurate. I counted 44, both on the real thing and the ldd mesh.

Thanks, that'll be helpful.

Hmm…44 teeth doesn't adapt quite as neatly to 16/48-prims as 40 would; it means subparting the flange into only 4 slices instead of 8. Is it better to go for the correct number of teeth, or streamline the geometry a bit with greater use of subparts?

For comparison, here's what I came up with for a 40-tooth version (pinhole not finished yet):
   

.zip   4208s01.zip (Size: 2.16 KB / Downloads: 2)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Part 4210 (hose reel) - by N. W. Perry - 2020-07-29, 16:31
RE: Part 4210 (hose reel) - by Alex Taylor - 2020-07-30, 6:56
RE: Part 4210 (hose reel) - by Alex Taylor - 2020-07-30, 6:57
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-30, 14:39
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-30, 17:35
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-31, 16:12
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-07-31, 19:06
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-01, 0:41
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-01, 7:08
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-02, 3:29
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-08-03, 23:16
RE: Part 4210 (hose reel) - by N. W. Perry - 2020-10-21, 15:03

Forum Jump:


Users browsing this thread: 2 Guest(s)