Parts we are Working on - Part Deux


RE: Parts we are Working on - Part Deux
#87
(2020-07-19, 21:46)Orion Pobursky Wrote: Answer: No. the TEXMAP spec requires a FALLBACK section.

The FALLBACK section is definitely not intended to be required, and in fact is explicitly stated in the spect to be impossible when using TEXMAP NEXT. If FALLBACK being completely optional is unclear in the TEXMAP spec, then the TEXMAP spec should probably be updated. When no fallback geometry is available, the FALLBACK section should not be present, and the untextured version of the TEXMAP geometry should be used instead. I don't think this is stated as a requirement anywhere, but perhaps it should be.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Brick rounded 3 x 3 - by Gerald Lasser - 2019-12-31, 16:46
45706 - Trainfront - by Gerald Lasser - 2020-02-28, 23:19
RE: 45706 - Trainfront - by Gerald Lasser - 2020-03-04, 23:04
RE: 45706 - Trainfront - by Gerald Lasser - 2020-03-05, 6:52
Minion Progress! - by Gerald Lasser - 2020-05-28, 20:10
RE: Minion Progress! - by Magnus Forsberg - 2020-05-28, 22:00
RE: Minion Progress! - by Vincent Messenet - 2020-05-29, 12:50
Mario plates - by Philippe Hurbain - 2020-06-16, 11:23
RE: Mario plates - by Philippe Hurbain - 2020-06-17, 13:15
RE: Parts we are Working on - Part Deux - by Travis Cobbs - 2020-07-20, 0:03
RE: Ghostbuster Ecto Windscreen - by SNIPE - 2020-11-07, 7:50
RE: Parts we are Working on - Part Deux - by Bruno Altmann - 2020-11-28, 22:32
RE: Parts we are Working on - Part Deux - by Bruno Altmann - 2020-11-29, 16:45
RE: Parts we are Working on - Part Deux - by Bruno Altmann - 2020-12-07, 1:04
Parts from 75300 and 75301 - by Gerald Lasser - 2020-12-05, 15:09
Escalator Part 69900 - by Gerald Lasser - 2021-02-06, 10:00

Forum Jump:


Users browsing this thread: 1 Guest(s)