How did universal Joint edit in LDCAD


RE: How did universal Joint edit in LDCAD
#6
(2018-12-30, 9:02)Philippe Hurbain Wrote:
Quote:How to change angle to connect two joints
The rotate pin, even in finest grid, can't go lower than 1°. So to get precise rotation you need to use the manual rotate tool where you are able to key in the rotation angle (toolbar round arrow, shortcut ctrl+r). Remember that you can put the angle value given by the measure tool sinply by clicking in the value box.

For more details, see the advanced editing tutorial, shock absorber section at bottom: http://www.melkert.net/LDCad/docs/advEdit

I  had read it carefully,but i wish know more detail  about it .

Help document content is too small :-(
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: How did universal Joint edit in LDCAD - by Shi.Yan - 2018-12-31, 1:31

Forum Jump:


Users browsing this thread: 2 Guest(s)