Using LDCad flexible parts with Studio


RE: 3 - Flexible parts that need segment changes
#12
(2020-03-29, 4:56)N. W. Perry Wrote: Unfortunately, I get some visible gaps in the render—does your template account for this? or is there some setting I can tweak?
Basically for LQ flex parts, the trick is to increase overlap between segments. To do that, lower "Segment size" below 100%. If the visual length of the segment must be preserved (ends of flex axle), increase "Base size" proportionnally.
I tweaked my flex axle template (http://www.brickshelf.com/gallery/Philo/...studio.ldr) because there were gaps in the ends of axles. I changed Segment size to 80% and Base size to 125%, now it looks good:
[Image: flexaxle.png]
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: 3 - Flexible parts that need segment changes - by Philippe Hurbain - 2020-03-29, 11:11

Forum Jump:


Users browsing this thread: 1 Guest(s)