LDCAD compass location

RE: LDCAD compass location
(2018-09-06, 6:45)Philippe Hurbain Wrote:
(2018-09-06, 0:10)Kathleen Kampf Wrote: Thanks, I am using your tutorial docs. But, now I have a new issue. The editing pin is not appearing when I place a brick. Thanks for the help with this.
Press "p" to hide/show edit pin. Sometimes it gets in the way, especially in rotate mode...
BTW, Roland, using a ring instead of a disc would make it less intrusive?

I have gotten through your tutorial doc. I have a basic understanding. I've been modeling rubber belts with success, THANK YOU very much. I actually need to make a figure 8 to go around two 1/2 bushes. In fact, the "x" section of it has to currve outside of 1 beam. Yah, it's kind of a fussy job. The figure 8 is what I really need the most help wiith. I accidently got an X when I was initially learning this. But, I don't know how it happened. Thanks for your help. This little job is the reason I began the LDCAD tutorial.
« Next Oldest | Next Newest »

Messages In This Thread
LDCAD compass location - by Kathleen Kampf - 2018-09-03, 19:34
RE: LDCAD compass location - by Owen Dive - 2018-09-04, 7:20
RE: LDCAD compass location - by Kathleen Kampf - 2018-09-08, 2:25

Forum Jump:

Users browsing this thread: 1 Guest(s)