LDCad 1.6b suport files test

RE: LDCad 1.6b suport files test
(2018-01-10, 20:53)Merlijn Wissink Wrote: Wow, that was quick! It seems to work perfectly fine too, only the origin of the part (in non-nested mode) is a bit weird.
Many thanks Roland! It will be put to good use in the nearby future  Big Grin

I did forget to shift to 0,0,0. You can do this in the template itself by selecting the thing you want a 0,0,0 followed by ctrl+a and shift+c . You need to do the same in any mpd using a copy of it just be sure to apply it in the subfile's own session and not through nesting.
« Next Oldest | Next Newest »

Messages In This Thread
RE: LDCad 1.6b suport files test - by Roland Melkert - 2018-01-10, 21:05

Forum Jump:

Users browsing this thread: 1 Guest(s)