75192 Millennium Falcon


RE: 75192 Millennium Falcon
#3
(2017-10-13, 12:18)Jaco van der Molen Wrote: Reaching step 378 I ran into something strange which is I think an illegal connection?
The red liftarm won't fit here?
Confirmed... If I build the model in LDCad, the distance between pins is 42.4 ldu. Situation is worse with LDD: pin holes are a bit closer to top of Technic brick (a well known LDraw approximation) making the diagonal pins even further apart at 43.1ldu. In any case, LDD refuses to fit the diagonal beam!

...good luck with this HUGE model!


Attached Files
.lxf   falcon.lxf (Size: 8.11 KB / Downloads: 30)
.ldr   falconldd.ldr (Size: 1.56 KB / Downloads: 26)
.ldr   falconldraw.ldr (Size: 726 bytes / Downloads: 26)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: 75192 Millennium Falcon - by 최 동진 - 2020-05-19, 14:26
RE: 75192 Millennium Falcon - by Philippe Hurbain - 2017-10-13, 13:29
RE: 75192 Millennium Falcon - by Travis Cobbs - 2017-10-13, 19:46
RE: 75192 Millennium Falcon - by Miguel - 2017-10-19, 11:51

Forum Jump:


Users browsing this thread: 1 Guest(s)