[LDPartEditor] 0.8.25 Beta Released (64bit only / usability / bugfix)


RE: [LDPartEditor] Problem with distance meter
#19
I think that deltax/y/z of diatance meter is somewhat buggy. The following code
Code:
0 !LPE DISTANCE 24 4 39.9985 -46 4 -4 -76
1 16 0 -4 -76 0 0 4 2.2532 43.9985 0 -3.3048 30 0 4-4cyli.dat
shows a distance of 53.2529 (correct), dx=43.9985 (for me this is dy, dx should be 0), dy=-28.3195 (should be 43.9985) and dz=9.8999 (should be 30)

(edit): I now realize that it depends on manipulator orientation. But if I set the manipulator to the origin of the cylinder, then the two selected vertices of distance meter are aligned with manipulator Y axis so I should have dx=dz=0, dy=cylinder length=53.2529? But I read dx=-30, dy=-36.3524, dz=-24.7866 ?!?
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: [LDPartEditor] Problem with distance meter - by Philippe Hurbain - 2016-10-24, 19:38
Limited internet access... - by Nils Schmidt - 2016-11-05, 11:20
Rectifier in LDPE - by Magnus Forsberg - 2016-11-27, 19:41

Forum Jump:


Users browsing this thread: 1 Guest(s)