LDCad 1.4b (win+linux)

Re: LDCad 1.4b (win+linux)
Ins will always insert the last used part / duplicate the selection so you might have not selected a circle last.

Also as the rubber band you drop into your model lives inside it's own ldr, so you must make sure you are editing that model or use the nested editing mode from the top level model.

Nested editing will be the easier way as you keep your whole model in view. You go into nested editing mode by selecting its tab in the top right session label panel.

I know nested editing can be confusing (I've been told Smile )

The pneumatic hose tutorial clip on youtube might give some insight into using nesting mode.

I'm also in the midst of writing documentation about generic (nested) editing.
« Next Oldest | Next Newest »

Messages In This Thread
LDCad 1.4b (win+linux) - by Roland Melkert - 2015-01-28, 23:04
LDCad 1.4b Documentation - by Roland Melkert - 2015-02-14, 23:54
Re: LDCad 1.4b (win+linux) - by Jason Smith - 2015-02-15, 6:39
Re: LDCad 1.4b (win+linux) - by Roland Melkert - 2015-02-19, 18:24
Re: LDCad 1.4b (win+linux) - by Owen Dive - 2015-04-01, 9:50
Re: LDCad 1.4b (win+linux) - by Owen Dive - 2015-03-13, 10:48

Forum Jump:

Users browsing this thread: 1 Guest(s)