Roland Melkert Wrote:I might add a template for the pneu hose without the ends. But you can easily make that one your self, just place a normal pneumatic hose and remove it's caps afterwards. Don't forget to ungroup them first.
That's what I did for the moment, but without the end cap there is no... well, cap. There's no surface or edge lines at the end of the hose. I'd need a replacement for 165.dat, a non-stretched hose end.
Quote:A bendable plain axle shouldn't be to hard to make yourself ether. You could use (a copy of) the existing flex system hose template and replace it's skin donors after placement.
I'll try, sure, I just didn't want to waste my time in case you already had it planned
