OK. So... if I wanted to create a part with a mirrored pattern, would it be accepted as an unofficial part (as I don't know if the mirrored pattern exists in reality)?
Is it possible to invert a pattern?
« Next Oldest | Next Newest »
| Messages In This Thread |
|
Is it possible to invert a pattern? - by Ignacio Fernandez Galvan - 2012-11-10, 20:42
Re: Is it possible to invert a pattern? - by Willy Tschager - 2012-11-10, 21:06
Re: Is it possible to invert a pattern? - by Ignacio Fernandez Galvan - 2012-11-12, 18:50
Re: Is it possible to invert a pattern? - by Michael Heidemann - 2012-11-12, 19:06
|
Users browsing this thread: 1 Guest(s)