(2023-11-24, 10:42)Gerald Lasser Wrote: It is indeed a different mould, thicket attachment point of the whisksand flattened.It's just a molding artefact... Nonetheless put it on PT with the notch: https://library.ldraw.org/tracker/33336
Why did they add the anti roll notch? SOmebody from workplace saftex did an audit?
Complete 3 Part requests
« Next Oldest | Next Newest »
| Messages In This Thread |
|
3 Part requests - by Orion Pobursky - 2023-11-23, 18:19
RE: 3 Part requests - by Vincent Messenet - 2023-11-23, 20:48
RE: 3 Part requests - by Orion Pobursky - 2023-11-23, 21:55
RE: 3 Part requests - by Javier Orquera - 2023-11-24, 1:01
RE: 3 Part requests - by Vincent Messenet - 2023-11-24, 7:42
RE: 3 Part requests - by Gerald Lasser - 2023-11-24, 10:42
RE: 3 Part requests - by Philippe Hurbain - 2023-12-09, 19:49
RE: 3 Part requests - by Philippe Hurbain - 2023-12-04, 10:43
RE: 3 Part requests - by Gerald Lasser - 2023-12-04, 17:06
RE: 3 Part requests - by Orion Pobursky - 2023-12-04, 17:59
RE: 3 Part requests - by Philippe Hurbain - 2023-12-05, 14:42
|
Users browsing this thread: 2 Guest(s)