Part request: 1626 - Large Figure Armor, Round, Smooth with Bar Handle - Free Ends
2023-04-05, 14:55
(This post was last modified: 2023-04-07, 7:42 by Gerald Lasser.)
2023-04-05, 14:55
(This post was last modified: 2023-04-07, 7:42 by Gerald Lasser.)
Hi there, I’m new so not really sure what to do. I’m after a 3D rendering of this relatively new part: 1686
https://www.bricklink.com/v2/catalog/cat...8#T=C&C=28
https://www.brickowl.com/catalog/lego-sh...shaft-1686
Here’s a different angle that shows the detail: https://www.toypro.com/us/product/49377/...e-ends/red
I’m building a model in Studio and tried to use PartDesigner to edit the slight variation of the part that they on file but I’m not savvy enough to get it working. I’ve put in a request on the PartDesigner forum but thought I could try here too. I’m not sure how the file types work. How transferable are they from program to program?
Thanks,
Corinne
https://www.bricklink.com/v2/catalog/cat...8#T=C&C=28
https://www.brickowl.com/catalog/lego-sh...shaft-1686
Here’s a different angle that shows the detail: https://www.toypro.com/us/product/49377/...e-ends/red
I’m building a model in Studio and tried to use PartDesigner to edit the slight variation of the part that they on file but I’m not savvy enough to get it working. I’ve put in a request on the PartDesigner forum but thought I could try here too. I’m not sure how the file types work. How transferable are they from program to program?
Thanks,
Corinne