Form Technic Axle Flexible with liftarms

RE: Form Technic Axle Flexible with liftarms
(2022-05-17, 17:57)Philippe Hurbain Wrote: These files are in my previous post (zip file). Are you sure you're using latest 1.7alpha2? Have you restarted LDCad after donnor file update?

Tricky isn't it?   Big Grin
Actually, I used axle connexion to allow auto-orientation of part. A pin connection might work in non-twisted configuration, but otherwise it's better to use a part with axlehole and replace it later with a beam.

Oops, my mistake. I worked with LDCad 1.6d. Blush

I have 1.7alpha2 too. That works better, but snapping is off sometimes.
Still, very promising. Thank you.

The only file in the zip is "twisted flex.mpd" BTW

[EDIT] Works good with axle holes, but then replacing with beams is difficult, since the center is elswhere.
Jaco van der Molen
« Next Oldest | Next Newest »

Messages In This Thread
RE: Form Technic Axle Flexible with liftarms - by Jaco van der Molen - 2022-05-17, 18:50

Forum Jump:

Users browsing this thread: 1 Guest(s)