Form Technic Axle Flexible with liftarms

RE: Form Technic Axle Flexible with liftarms
(2022-05-17, 13:29)Philippe Hurbain Wrote: Tricky...
I'd try to create segments of flexible axle parts duplicated (to make both rails), a special segment with beam+2 axle segments, then create a special LDCad template using those segments. But imho it's worth the trouble only if you have many similar bent parts to do!

Ah yes, OK. I think I know what you mean.
The thing is I have a model that has quite a few more of these constructions in all sorts of forms and curves and even more complex, twisted too, like a DNA streng, if you know what I mean.

In the model if have in mind there are even more liftarms on the axle and those are actually closer to eachother so you get a very nice curve, if you can get the idea.
On the ends of the axle there are half pins so you can connect to other technic beams and elements with pin holes.
Jaco van der Molen
« Next Oldest | Next Newest »

Messages In This Thread
RE: Form Technic Axle Flexible with liftarms - by Jaco van der Molen - 2022-05-17, 14:09

Forum Jump:

Users browsing this thread: 1 Guest(s)