Formed sticker on non-cylindrical surface
2021-03-13, 11:26 (This post was last modified: 2021-06-20, 6:57 by Takeshi Takahashi.)
2021-03-13, 11:26 (This post was last modified: 2021-06-20, 6:57 by Takeshi Takahashi.)
I'd like to make a formed sticker of 4620859d
https://www.ldraw.org/cgi-bin/ptdetail.c...20859d.dat
to put on a bucket 48245.
https://www.bricklink.com/v2/catalog/cat...7#T=C&C=47
As the side surface of bucket is not cylindrical,
the Pattern Folder web-app by Lasse cannot be used.
Are there any smart ways for creating this sticker,
or should I cut the pattern manually with tweaking the coordinates in LDPE?
Thanks,
Takeshi
[Edit] 2021-06-20
Thanks again for a lot of advice.
The part has been admin-certified and will be included in next release.
https://www.ldraw.org/cgi-bin/ptdetail.c...20859d.dat
to put on a bucket 48245.
https://www.bricklink.com/v2/catalog/cat...7#T=C&C=47
As the side surface of bucket is not cylindrical,
the Pattern Folder web-app by Lasse cannot be used.
Are there any smart ways for creating this sticker,
or should I cut the pattern manually with tweaking the coordinates in LDPE?
Thanks,
Takeshi
[Edit] 2021-06-20
Thanks again for a lot of advice.
The part has been admin-certified and will be included in next release.