LDCad Some Gear Rotations are "disconnected"

RE: Some Gear Rotations are "disconnected"
(2020-10-21, 8:45)Max Martin Richter Wrote: If you go with the default option of 15 degrees the teeth will visually not rotate, cause there is one tooth each 15 degrees. ;-)

If you want to adjust the gears correctly, you need to calculate them separately as written in another post.
As I do this always you can just search for a technic model done by me in the OMR. ;-)

I used 1 degree increments and can see the hub rotating but the teeth do not. This only happens with the gears i have mentioned.
« Next Oldest | Next Newest »

Messages In This Thread
RE: Some Gear Rotations are "disconnected" - by NikosSprocket - 2020-11-10, 8:02

Forum Jump:

Users browsing this thread: 1 Guest(s)