[LPub] Change the view of a Callout

[Johann Eisner]

Hi Johann,
Thank you for your answer. Unfortunately, it didn't work for me. The code looks like this:

0 FILE part.mpd
0 Name: Part
0 !LPUB CALLOUT PLI PER_STEP GLOBAL FALSE
0 ROTATION CENTER 0 0 0 1 "Custom"
0 ROTATION CONFIG 0 0
1 0 8.787 -8 -31.213 0.707107 0 0.707107 0 -1 0 0.707107 0 -0.707107 3023.dat
1 0 15.858 0 -24.142 -0.707107 0 -0.707107 0 -1 0 -0.707107 0 0.707107 63864.dat
1 0 51.213 0 -31.213 -0.707107 0 0.707107 0 -1 0 0.707107 0 0.707107 3069b.dat
1 0 44.142 -8 -24.142 -0.707107 0 0.707107 0 -1 0 0.707107 0 0.707107 3623.dat
1 1 30 -16 -10 0.707107 0 -0.707107 0 -1 0 -0.707107 0 -0.707107 2420.dat
0 STEP
0 !LPUB CALLOUT BEGIN
1 1 0 -40 0 1 0 0 0 -1 0 0 0 1 1.ldr
0 !LPUB CALLOUT PLACEMENT RIGHT CENTER ASSEM OUTSIDE OFFSET 0.4866 -1.7853
0 !LPUB CALLOUT END
0 STEP
0 NOFILE
0 FILE 1.ldr
0 Name: 1.ldr
0 Author: Manfred Schäfer
0 ROTSTEP 0 0 0 REL
1 1 30 0 -20 1 0 0 0 1 0 0 0 1 3003.dat
0 STEP
1 1 20 -16 -10 0 0 1 0 1 0 1 0 0 6091.dat
1 1 20 -16 -30 0 0 1 0 1 0 1 0 0 6091.dat
1 1 40 -16 -10 0 0 -1 0 1 0 -1 0 0 6091.dat
1 1 40 -16 -30 0 0 -1 0 1 0 -1 0 0 6091.dat
0 STEP
1 1 30 -16 -30 1 0 0 0 1 0 0 0 -1 3794a.dat
1 1 30 -16 -10 1 0 0 0 1 0 0 0 -1 3069b.dat
0 STEP
0 NOFILE

The result (2nd page) looks like this:
What I expected or how it should be is like this:
I use the Version 2.3.13 (latest Version)

Regards
Manfred

Hi Manfred

I have no idea why it doesn't work for you, but the following solution:
Replace the ROTSTEP command in the callout submodel (Marked red above)with "0 ROTSTEP 0 0 180 REL" then it should work for you too.

Regards Johann