[LPub] Change the view of a Callout

[Manfred Schaefer]

Hi

Did you change anything in the matrix?
The correct line for the second callout should be:
1 19 0 -24 0 -1 0 0 0 1 0 0 0 -1 Sub 21002-001.ldr

Philos opinion was you should insert the ROTSTEP command in front of the code in the callout.
Between the header an the first part line..
But this will probably not cause any change, except that the first callout is then also rotated.

Johann

Thanks Johann.
First I used the matrix to rotate the sub part, but the parts in the callout was also rotated. I can not make any changes in the sub part as this will affect the first time the sub part is used.

Regards

Manfred