[LDCad] Configuration problem?

RE: [LDCad] Configuration problem?
(2020-01-14, 17:16)Philippe Hurbain Wrote: Suddenly my LDCad behaves weirdly with steps: each time I add a step, the 3D view is reset to default orientation and zoomed to fit.

It's for inspecting the rotation step stuff. If you don't need it you could clear the hotkey so you don't enable it by accident.
« Next Oldest | Next Newest »

Messages In This Thread
RE: [LDCad] Configuration problem? - by Roland Melkert - 2020-01-14, 20:20

Forum Jump:

Users browsing this thread: 1 Guest(s)