need help with chains


RE: need help with chains
#5
(2019-08-07, 20:31)Stefan Weinert Wrote: Hi Johann,
i used the only changeable part for chains. I think I used the LQ model like the flex hose, flex axis and cables. How can I find that out in LDCad? If I go to the submodel, I find the following text (see pdf)...
...the bottom picture is the result when i do phillipe's change in nested mode

Hi again
Quick and dirty solution, maybe not the correct way, but it works.
Open your file with Editor
Edit ---> Replace...
Search: 30104k01.dat
Replace with: 208.dat

Search: 30104k02.dat
Replace with: 209.dat

Save the file.
Enjoy!


Attached Files
.png   Chain1.PNG (Size: 131.85 KB / Downloads: 67)
If nothing goes right, go left.
Reply
« Next Oldest | Next Newest »



Messages In This Thread
need help with chains - by Stefan Weinert - 2019-08-07, 15:07
RE: need help with chains - by Johann Eisner - 2019-08-07, 19:44
RE: need help with chains - by Stefan Weinert - 2019-08-07, 20:31
RE: need help with chains - by Johann Eisner - 2019-08-07, 20:40
RE: need help with chains - by Johann Eisner - 2019-08-07, 21:11
RE: need help with chains - by Stefan Weinert - 2019-08-08, 14:06
RE: need help with chains - by Stefan Weinert - 2019-08-08, 14:18
RE: need help with chains - by Roland Melkert - 2019-08-08, 16:57
RE: need help with chains - by Stefan Weinert - 2019-08-09, 14:59

Forum Jump:


Users browsing this thread: 1 Guest(s)