3D Part Preview added to Parts Tracker


RE: 3D Part Preview added to Parts Tracker
#50
(2019-07-20, 18:12)Orion Pobursky Wrote: No. A combo of stud.dat with logo.dat.
That would be the one you get when you set the stud type to 1, right? (stud.dat is the one with square sides, while logo.dat is the single line edge draw type)

[Image: 123.png]
Reply
« Next Oldest | Next Newest »



Messages In This Thread
RE: 3D Part Preview added to Parts Tracker - by Lasse Deleuran - 2019-07-21, 8:52

Forum Jump:


Users browsing this thread: 1 Guest(s)