LDCAD compass location

RE: LDCAD compass location
(2018-09-21, 19:51)Kathleen Kampf Wrote: Thanks, I tried this today. I was able to form my figure 8 but, part of it appears flat like tape and another portion looks wrinkled. I am happy it's twisted now.

You need to make sure the 'roll' orientation is correct when using the bezier points. It's indicated by the red/blue arrows. The difference between two connected ones should be less then 180 degrees or the underneath math will do funny things Smile
« Next Oldest | Next Newest »

Messages In This Thread
LDCAD compass location - by Kathleen Kampf - 2018-09-03, 19:34
RE: LDCAD compass location - by Owen Dive - 2018-09-04, 7:20
RE: LDCAD compass location - by Roland Melkert - 2018-09-21, 20:02

Forum Jump:

Users browsing this thread: 1 Guest(s)