LDCAD compass location

RE: LDCAD compass location
(2018-09-04, 19:31)Roland Melkert Wrote:
(2018-09-04, 13:15)Kathleen Kampf Wrote: Great, Thanks. I'll make sure I learn that. I assume that rotation steps are done some how. Also, I see submodeling is available. It took me a very long time to learn MLCAD. But if LDCAD also does everything I need, I may end up using it more. We'll see.

You can use any normal step as a rotation step by editing the current step properties using ctrl+b

Do note this is not possible for the last or only step in a model as LDraw steps indicate the ending of a step.

If you want to get productive with LDCad reading my short tutorials might get you started.

Of which the "advanced editing" one explains LDCad's submodel use.

Thanks, I am using your tutorial docs. But, now I have a new issue. The editing pin is not appearing when I place a brick. Thanks for the help with this.
« Next Oldest | Next Newest »

Messages In This Thread
LDCAD compass location - by Kathleen Kampf - 2018-09-03, 19:34
RE: LDCAD compass location - by Owen Dive - 2018-09-04, 7:20
RE: LDCAD compass location - by Kathleen Kampf - 2018-09-06, 0:10

Forum Jump:

Users browsing this thread: 1 Guest(s)