[LDPartEditor] 0.8.24 Beta Released (Rounding per X,Y,Z / bugfix)

RE: [LDPartEditor] Problem with Edger2 "precision"
So... maybe it's not a general problem, but here is a buggy case. LDPE Edger2 with default settings generates unmatched lines everywhere (****). With increased precision value (from 0.001 to 1), no unmatched line is created between quads (so precision parameter does have an influence)... but no condline either!
(****) Default precision value of LDPE Edger2 is 0.0001, which is pretty low. Regular Edger2 default is 0.001, a value validated by years of usage...

Attached Files
.dat   bugedger.dat (Size: 547 bytes / Downloads: 1)
« Next Oldest | Next Newest »

Messages In This Thread
What is "epic"? - by Nils Schmidt - 2016-09-08, 18:56
RE: [LDPartEditor] Problem with Edger2 "precision" - by Philippe Hurbain - 2016-09-27, 18:46

Forum Jump:

Users browsing this thread: 1 Guest(s)