"Wrapping" Tool
2015-02-04, 10:06 (This post was last modified: 2015-05-05, 13:36 by Gerald Lasser.)
2015-02-04, 10:06 (This post was last modified: 2015-05-05, 13:36 by Gerald Lasser.)
Before I start my own rudimentary coding, I thingk I better ask.
I am looking for a tool that allows me to wrap Stickers around a certain shape, e.g. the Santa Fe front sticker, some Panels etc.
If those stickers are made from the scanned sheet itself some distortion will occur, proper rotation of the destination part will reduce these effects when using SlicerPro.
Howver with Stickers "around the corner", like the Santa Fe one, the result is too distorted. The output gets streched too much to be visually pleasing.
Now I though of doing a small script that "bends" the sticker along the edges that the parts provide. For the Santa Fe thsi would be the outer surface of the 6005.dat
The question is if somebody has already done such a tool or which tool can do this?
Thanks
Gerald
I am looking for a tool that allows me to wrap Stickers around a certain shape, e.g. the Santa Fe front sticker, some Panels etc.
If those stickers are made from the scanned sheet itself some distortion will occur, proper rotation of the destination part will reduce these effects when using SlicerPro.
Howver with Stickers "around the corner", like the Santa Fe one, the result is too distorted. The output gets streched too much to be visually pleasing.
Now I though of doing a small script that "bends" the sticker along the edges that the parts provide. For the Santa Fe thsi would be the outer surface of the 6005.dat
The question is if somebody has already done such a tool or which tool can do this?
Thanks
Gerald