How to "inline" a sub-model?

How to "inline" a sub-model?
I noticed that Tore Eriksson "inlined" a lot of parts in Datsville in the past. I'm not sure exactly what that means, but I'm guessing it means removing a model from a sub-assembly and placing it in a higher-level parent model without messing up the model's position.

I would like to do the same. I would like to extract minifigures from within individual MPD models and place them in a higher "traffic" layer without screwing up their positions.

Am I being clear? How do I accomplish this?
« Next Oldest | Next Newest »

Messages In This Thread
How to "inline" a sub-model? - by Michael Horvath - 2013-11-16, 20:55

Forum Jump:

Users browsing this thread: 1 Guest(s)