Hi, maybe this could help?
I made a crude mock-up of this part some years ago.
I'ts not very good but I hope that at least the dimensions are right.
It's made in MLCad Baseplate Generator and opens with studs in MLCad, but without studs in LDView.
Use it or loose it...;-)
I made a crude mock-up of this part some years ago.
I'ts not very good but I hope that at least the dimensions are right.
It's made in MLCad Baseplate Generator and opens with studs in MLCad, but without studs in LDView.
Use it or loose it...;-)