Re: Compatibility issue in MPD submodel file names between MLCad and Bricksmith
2013-04-29, 16:41
2013-04-29, 16:41
I think MLCad does it the right way.
But in the end Bricksmith should still be able to find the submodel, cause references should be handled case insensitive (even on a *nix fs). This is needed because loads of official parts use wrong casing in type 1 lines.
Just my 2cts
But in the end Bricksmith should still be able to find the submodel, cause references should be handled case insensitive (even on a *nix fs). This is needed because loads of official parts use wrong casing in type 1 lines.
Just my 2cts
![Smile Smile](https://forums.ldraw.org/images/smilies/smile.png)