New (unofficial) part not recognized by MLCad

[Jaco van der Molen]

Hi all,

There is a strange problem going on I cannot solve.

I have added a new unofficial part to my library downloaded from the partstracker.
It concerns part 11211 Brick, Modified 1 x 2 with Studs on 1 Side.

I have put it in <LDRAWDIR>Unofficial\Parts and I use the [SCAN_ORDER] option in MLCad.ini.
However MLCad cannot find the part.
I generated a new partslist from MLCad... no succes. The part is not in the list.
So I decided to put the parts in the official parts folder and generate a new parts.lst file using good old mklist.
It ended up in the parts list just fine.
However, it does NOT show in MLCad and I cannot find it.

I have put it in my model using Insert new part and then browse for it in <LDRAWDIR>\Parts\11211.dat. It added it just fine to the model and it showed. Saving the model, closing MLCad, start MLCad again en open the file gives an error:
File 11211.dat not found! Continue loading?

Putting the part file in the same folder as my model does not help either.
How is this possible? Any thoughts?

Thanks.

Jaco