Thanks! I only see gap from below where t01o1250 meets cone. There you can simply use a thin ring that slightly enter the cone to fill the gap (high diameter ring scaled down).
Otherwise you'll have to run Edger2 with expand subfile option to create additional condlines where top torus meets outer top cone. Maybe also add condlines where cone meets cylinder at bottom, but here it can be questionned as the slight break effet is rather nice (and condlines are not mandatory since it's a concave junction).
Otherwise you'll have to run Edger2 with expand subfile option to create additional condlines where top torus meets outer top cone. Maybe also add condlines where cone meets cylinder at bottom, but here it can be questionned as the slight break effet is rather nice (and condlines are not mandatory since it's a concave junction).