Here is the bucket (without the handle connectors) just for checking it against errors.
I have found some very very small gaps where the tori meets the cones. So I tried to set the scaling factor of the tori to another value...but then I must use 5 different tori to cover the area where it is actually done with one cone.
(Scalling factor 24.5007 for the tori)
Don't know what to do here.
/Max
I have found some very very small gaps where the tori meets the cones. So I tried to set the scaling factor of the tori to another value...but then I must use 5 different tori to cover the area where it is actually done with one cone.
(Scalling factor 24.5007 for the tori)
Don't know what to do here.
/Max