Hi Yuntao,
Datheader utility can help you fill in the header without mistakes, and also verifies a lot of things in your file.
The ultimate improvement would be to put all common geometry in a subfile, build 91968 from that and update 64424 to use the subpart.
Yuntao Chen Wrote:Perhaps I can put the pin on the 91994.dat, just like the metal axle in 2879c01.dat.It's better to make it a separate parts, as you already did.
If this is appropriate...
Quote:Furthermore, I didn't build this part from start to finish.As this is a brand new part, even if part of it is derived from another part, author should be set to your name and !HISTORY should be emptied. You may mentionned as comment that part is derived from another one, but I am the author of this other part and won't take offence if you don't
So, I'm not sure how to change the contents of the header.
Can you give me some suggestions? Such as "Author", "!HISTORY", etc...
Datheader utility can help you fill in the header without mistakes, and also verifies a lot of things in your file.
The ultimate improvement would be to put all common geometry in a subfile, build 91968 from that and update 64424 to use the subpart.