Is it possible to invert a pattern?


Is it possible to invert a pattern?
#1
In the attached model, the red piece has the arrow pointing backward, and I'd like it pointing forward. Is it possible without creating a new part?

I could just multiply by "-1" the appropriate dimension, but that would be unphysical, causes problems in LDCad and would invert the stud logos in some case (in POV-Ray, for instance). It works with LDView, though.


Attached Files
.ldr   test.ldr (Size: 716 bytes / Downloads: 0)
Reply
« Next Oldest | Next Newest »



Messages In This Thread
Is it possible to invert a pattern? - by Ignacio Fernandez Galvan - 2012-11-10, 20:42

Forum Jump:


Users browsing this thread: 2 Guest(s)