Hi,
Sorry, should have included this information before. I am using:
MLCAD v 3.4 (latest), with latest ldconfig (all installed using the new all-in-one installer)
POV-Ray RC 6 (not the latest but RC 8 is very similar)
The computer has just been formatted, so there is no possibility of older versions of these files lingering in the system.
To convert between MLCAD and POV-Ray I simply export the files to a folder and then use L3PAO to generate the .pov file from the exported MLCAD document (by exporting, it removes all references to submodels, which L3PAO cannot handle). This was a method I worked out myself, so it might be the cause of the problem...
Apologies for the poor image link - the URL was to the folder, not the image (I used to make exactly the same mistake on the Classic Space forums, all those years ago). Now fixed.
Sorry, should have included this information before. I am using:
MLCAD v 3.4 (latest), with latest ldconfig (all installed using the new all-in-one installer)
POV-Ray RC 6 (not the latest but RC 8 is very similar)
The computer has just been formatted, so there is no possibility of older versions of these files lingering in the system.
To convert between MLCAD and POV-Ray I simply export the files to a folder and then use L3PAO to generate the .pov file from the exported MLCAD document (by exporting, it removes all references to submodels, which L3PAO cannot handle). This was a method I worked out myself, so it might be the cause of the problem...
Apologies for the poor image link - the URL was to the folder, not the image (I used to make exactly the same mistake on the Classic Space forums, all those years ago). Now fixed.