MLCad v3.4 rotation problem
2012-09-02, 14:09 (This post was last modified: 2015-02-09, 8:05 by Philippe Hurbain.)
2012-09-02, 14:09 (This post was last modified: 2015-02-09, 8:05 by Philippe Hurbain.)
As this is my first post, i'd like to say hello. Hey all! 
Now, on to my problem.
I've just upgraded to MLCad v3.4 after using 3.1 for a long time. Everything is fine, however i've noticed when i select a part (or group of parts) and go to <right click> 'Enter Pos. + Rot.', i can't choose 'Use Rotation Vector Values'.
I've seen another post on this forum about the same problem, and the response was 'something got broke and hasn't been fixed', but that was five months ago and i was wondering if something HAS been fixed and i just don't know about it.
If it is still broken, is there a workaround to get a part to rotate less than the fine grid measurement of 15 degrees? I guess i could set the grid default to the desired angle, but i never KNOW the actual angle i'm after beforehand. I always adjust the angle until it sits where i want.
Any help or information would be most appreciated.
Thanks in advance.
haz-
Now, on to my problem.I've just upgraded to MLCad v3.4 after using 3.1 for a long time. Everything is fine, however i've noticed when i select a part (or group of parts) and go to <right click> 'Enter Pos. + Rot.', i can't choose 'Use Rotation Vector Values'.
I've seen another post on this forum about the same problem, and the response was 'something got broke and hasn't been fixed', but that was five months ago and i was wondering if something HAS been fixed and i just don't know about it.
If it is still broken, is there a workaround to get a part to rotate less than the fine grid measurement of 15 degrees? I guess i could set the grid default to the desired angle, but i never KNOW the actual angle i'm after beforehand. I always adjust the angle until it sits where i want.
Any help or information would be most appreciated.
Thanks in advance.
haz-