(2026-10-05, 1:06)Orion Pobursky Wrote: - If I delete the config folder, the GUI starts (after the license and ldraw folder dialogs). If I close and then reopen, the GUI doesn't start unless I delete the config folder again.
- I do run the program to the command line. That's how I figured out I needed to install glu. However, there are no messages.
- Based on my experience with building LDView for the LDraw server, there are some differences between Debian and Ubuntu.
- I did some experimentaion. The program does run normally if I run as root (e.g. sudo LDCad).
Very weird. Bydefault (without a overiding ldcad.cfg) it will not write or read outside the binairy folder. So the root thing is very weird.
I will need to find the time to get a live version running of your Ubuntu version. Figure out what changed. I'm hoping later this week.