LDCad 1.7 Beta 2b (win+linux)

[Orion Pobursky]

So after the delete of config it did run?

The log shows nothing special. 

Sometimes on Linux the OpenGL initialisation fails, but it would still show the gui just all black.

If you start the executable from a command line, it should show extra information.

Currently I compile the Linux versions on Debian 9 for maximum support, but it might be time to compile on something newer.

ps: the older links are disabled to limit traffic.

- If I delete the config folder, the GUI starts (after the license and ldraw folder dialogs).  If I close and then reopen, the GUI doesn't start unless I delete the config folder again.
- I do run the program to the command line.  That's how I figured out I needed to install glu. However, there are no messages.
- Based on my experience with building LDView for the LDraw server, there are some differences between Debian and Ubuntu.
- I did some experimentaion.  The program does run normally if I run as root (e.g. sudo LDCad).