(2026-05-05, 19:41)Chris Böhnke Wrote: I've started, but didn't go far (only split in half)... There's quite a lot of collisions with a minifig head in the BIA mesh which I'd say need to be fixed:
Not too mention the front half is supposed to sit close to the head underneath and needs to be adjusted to the head's cylinder.
Any tips on how to approach this? I also wouldn't mind if anyone else wants to take over.
Put a partial head insdie:
1 9 0 4 0 0 0 8 0 -6.4 0 -8 0 0 t04o6250.dat
1 9 0 4 0 -8 0 0 0 -6.4 0 0 0 -8 t04o6250.dat
1 9 0 4 0 13 0 0 0 23 0 0 0 -13 2-4cyli.dat
See where surfaces cut into the cyli, mark vertices match nearly the 16 sided geometry select them and select either "move to nearest edge" or "surface" this will adapt the shape to the head