One other issue with the spec.
Currently we use the "name" of the set to separate it if there are two sets with the same number.
http://guide.lugnet.com/set/6901
6901 - Mobile Lab.mpd
6901 - Space Plane.mpd
If we are inside the MPD we use then the qualifier number to separete the submodels from the different sets.
6901-1 Hatch.ldr
6901-2 Minifig.ldr
So if I have separated the submodel from one of the MPD files I have no chance to see to which set it really belongs. In my eyes this is really a bad solution.
If we use also the <qualifier> for the MPD name it would be clear.
Currently we use the "name" of the set to separate it if there are two sets with the same number.
http://guide.lugnet.com/set/6901
6901 - Mobile Lab.mpd
6901 - Space Plane.mpd
If we are inside the MPD we use then the qualifier number to separete the submodels from the different sets.
6901-1 Hatch.ldr
6901-2 Minifig.ldr
So if I have separated the submodel from one of the MPD files I have no chance to see to which set it really belongs. In my eyes this is really a bad solution.
If we use also the <qualifier> for the MPD name it would be clear.