Hi,
I have for a few years been wanting to upscale set 42145 so that it looks right with the lego dune ornithopter blades
But whenever I try by just reading the instruction manual, I either upscale only one or 2 axis and not 3, or I upscale all 3 axis but it looks weird (the wheels were way to far apart)
So, I thought it might be a good idea to have a reference model that is blown up in LDCAD
Therefore I am wondering if this is possible, or would up-scaling a part also shift its position,and then the whole model will look like a salad.
Here is the model
I have for a few years been wanting to upscale set 42145 so that it looks right with the lego dune ornithopter blades
But whenever I try by just reading the instruction manual, I either upscale only one or 2 axis and not 3, or I upscale all 3 axis but it looks weird (the wheels were way to far apart)
So, I thought it might be a good idea to have a reference model that is blown up in LDCAD
Therefore I am wondering if this is possible, or would up-scaling a part also shift its position,and then the whole model will look like a salad.
Here is the model