RE: Importing protocol from CATIA,Solidworks or AutoCAD
2025-09-06, 22:45 (This post was last modified: 2025-09-06, 22:49 by Chris Böhnke.)
2025-09-06, 22:45 (This post was last modified: 2025-09-06, 22:49 by Chris Böhnke.)
Export from your to .obj works as well.
1) CAD -> obj
2) obj (via Bricklink Studio's Part Designer) -> dat
3) cleanup .dat for use in LDraw
As Willy mentioned above, it is advisable to already model in LDU, otherwise you would need to re-scale.
EDIT:
Assuming your model is in millimeters that takes a scaling factor of 250% when importing to Studio.
1) CAD -> obj
2) obj (via Bricklink Studio's Part Designer) -> dat
3) cleanup .dat for use in LDraw
As Willy mentioned above, it is advisable to already model in LDU, otherwise you would need to re-scale.
EDIT:
Assuming your model is in millimeters that takes a scaling factor of 250% when importing to Studio.