also it seems like both the drill thing on the front i a plate high and the drill holes on the bottom are missing
since its a 2.0 part requires rewrite btw
since its a 2.0 part requires rewrite btw
71613/30346c01 too high?!
« Next Oldest | Next Newest »
| Messages In This Thread |
|
71613/30346c01 too high?! - by Sylvain Sauvage - 2025-05-16, 18:18
RE: 71613/30346c01 too high?! - by Gerald Lasser - 2025-05-16, 22:20
RE: 71613/30346c01 too high?! - by Magnus Forsberg - 2025-05-17, 10:39
RE: 71613/30346c01 too high?! - by Sylvain Sauvage - 2025-05-17, 13:11
RE: 71613/30346c01 too high?! - by Jeff Jones - 2025-05-17, 13:28
RE: 71613/30346c01 too high?! - by Pawel2 - 2025-05-17, 15:36
RE: 71613/30346c01 too high?! - by Philippe Hurbain - 2025-05-17, 16:09
RE: 71613/30346c01 too high?! - by Pawel2 - 2025-05-17, 17:25
RE: 71613/30346c01 too high?! - by Rene Rechthaler - 2025-05-17, 17:43
RE: 71613/30346c01 too high?! - by Orion Pobursky - 2025-05-17, 19:53
RE: 71613/30346c01 too high?! - by Orion Pobursky - 2025-05-17, 19:54
|
Users browsing this thread: 7 Guest(s)