(Yesterday, 9:44)Peter Blomberg Wrote: What would it take to get this on to the parts tracker? What does 'cleaning' entail? Is that something I can (are allowed to) do?
Most of the job is to get the surface ridges properly in place. As this is the raw mesh I haven't checked how good it is and how many of them are intersecting the surface.
Cleaning, means getting rid of those intersections, adding proper prims for the rounded corners, subfiling for symmetry etc. I would simplyfy the fillets at the underside to just boxes instead of the rounded fillets.
Of course you are allow to do, you have to ;-)
I would only say, if somebody expressed the intention to work on a part before, but nothing is coming, PM the person to check if something is in the works or you can go ahead.