+- LDraw.org Discussion Forums (https://forums.ldraw.org)
+-- Forum: Models and Parts (https://forums.ldraw.org/forum-18.html)
+--- Forum: Part Requests (https://forums.ldraw.org/forum-30.html)
+--- Thread: [Solved] Duplo parts 77274 and 73540 (/thread-28414.html)
Duplo parts 77274 and 73540 - Lawford - 2024-09-15
I'm looking for a couple of Duplo parts to complete a model but I don't think they are available yet?
Track Raised Ramp 12 x 6 x 8 Item No: 77274
Duplo Track Raised Ramp 8 x 8 x 1 Item No: 73540
RE: Duplo parts 77274 and 73540 - Gerald Lasser - 2024-09-15
Do you own them?
I did not find good enough pictures on the net that show me the structure of the road surface
RE: Duplo parts 77274 and 73540 - Lawford - 2024-09-15
RE: Duplo parts 77274 and 73540 - Gerald Lasser - 2024-09-20
Thanks for th epics! those should help!
RE: Duplo parts 77274 and 73540 - Gerald Lasser - 2024-09-22
77274 is on the tracker
https://library.ldraw.org/tracker/40508
73540 is available as a raw file, I haven't cleaned, only corrected Origin, it is attached here
RE: Duplo parts 77274 and 73540 - Lawford - 2024-09-22
(2024-09-22, 11:11)Gerald Lasser Wrote: 77274 is on the tracker
https://library.ldraw.org/tracker/40508
73540 is available as a raw file, I haven't cleaned, only corrected Origin, it is attached here
Thank you so much Gerald. That's excellent, I'll look forward to adding them to the model.
RE: Duplo parts 77274 and 73540 - Peter Blomberg - 2025-03-15
(2024-09-22, 11:11)Gerald Lasser Wrote: 77274 is on the tracker
https://library.ldraw.org/tracker/40508
73540 is available as a raw file, I haven't cleaned, only corrected Origin, it is attached here
What would it take to get this on to the parts tracker? What does 'cleaning' entail? Is that something I can (are allowed to) do?
RE: Duplo parts 77274 and 73540 - Gerald Lasser - 2025-03-15
(2025-03-15, 9:44)Peter Blomberg Wrote: What would it take to get this on to the parts tracker? What does 'cleaning' entail? Is that something I can (are allowed to) do?
Most of the job is to get the surface ridges properly in place. As this is the raw mesh I haven't checked how good it is and how many of them are intersecting the surface.
Cleaning, means getting rid of those intersections, adding proper prims for the rounded corners, subfiling for symmetry etc. I would simplyfy the fillets at the underside to just boxes instead of the rounded fillets.
Of course you are allow to do, you have to ;-)
I would only say, if somebody expressed the intention to work on a part before, but nothing is coming, PM the person to check if something is in the works or you can go ahead.